Claude Code Just Stops

I seem to have the same problem.

```
[DEBUG] Stream started - received first chunk
[DEBUG] Executing hooks for Stop
[DEBUG] Getting matching hook commands for Stop with query: undefined
[DEBUG] Found 0 hook matchers in settings
[DEBUG] No match query, returning all 0 hooks
[DEBUG] Found 0 hook commands to execute
[DEBUG] Executing hooks for UserPromptSubmit
[DEBUG] Getting matching hook commands for UserPromptSubmit with query: undefined
[DEBUG] Found 0 hook matchers in settings
[DEBUG] No match query, returning all 0 hooks
[DEBUG] Found 0 hook commands to execute

> continue...

[DEBUG] Stream started - received first chunk
[DEBUG] Executing hooks for Stop
[DEBUG] Getting matching hook commands for Stop with query: undefined
[DEBUG] Found 0 hook matchers in settings
[DEBUG] No match query, returning all 0 hooks
[DEBUG] Found 0 hook commands to execute
```

I ran an update and it seems to have downgraded my version of claude.

```
Using global installation update method...
Successfully updated from 1.0.54 to version 1.0.53
```

Note: only running one session.

> something wrong today?

● I'm working fine today! Is there something specific you'd like help with in your xxxx project?

> you start on something, then it goes quiet. almost as if you're freezing

● I understand the concern. That shouldn't be happening - I should complete tasks and respond consistently.

What specific task were you working on when this happened? I can help troubleshoot or pick up where we left off.

Yes, happening to me as well.

https://status.anthropic.com/ says everything is good. What is the official way to notify Claude folks?

Hope we are not seeing a classic bystander effect here.. everyone notices the issue, but since everything’s green and visible to all, no one’s actually stepping in to escalate this to anthropic.