.png)
1 day ago
1
Millimeters
Inches
? Note that all this does is enable fractions (eg. 2 1/8) to be processed. Behind the scenes everything is processed in "units", thus using inches is 25.4 times less precise than mm.
Output Settings:
Line Length:
? The length of the lines drawn in the output DXF
Output offset:
? Shifts the output, for example if you want to cut on the right of the marks you would shift the output by minus half a blade width (like -1.35)
Display Extra Geometries
? Draws debug geometries in the DXF, pay no attention to the man behind the curtain!
Algorithm type:
? This software offers two different algorithms. "Primary" works best for most cases. "Simple-symmetric" is only useful if you want the cuts to be symmetrical, it works only on simple curves (parabolas and similar).
